RC Logger 88002RC, Руководство по эксплуатации

Страница: 19 / 40

19
dIP switches
1 Parameter settings sport
2 Parameter settings user
3 Boot loader mode
4 RC configuration
5 No function yet defined
6 No function yet defined
Before you begin programming, unplug the rechargeable battery, if connected, from the RC EYE 450. Also
disconnect the connection cable to the PC, if connected, from the RC EYE 450.
1. Switch the DIP 4 on the QC-09 to ON position. On one side of the QC-09, both of the LEDs (LD1, LD2)
indicate particular operating statuses.
before switching the transmitter on, set the throttle stick to “motors off” and all trim
levers / trim sliding controllers of the pilot stick to the neutral position. otherwise, the
rC eye 450 may not recognise the transmitter after the battery is connected.
2. Now switch on the transmitter. Ensure that all levers and trims of the transmitter are in neutral position.
The example given shows the procedure using a remote control in mode 2. If you prefer to use another
mode, the axes used may differ (see chapter “Possible flight modes”)! Also ensure that the sliding
controller for the trim is set to neutral position! Otherwise correct recognition of the channels will not be
possible! Ensure that lever movements are made in the right direction, otherwise the signals will be
memorised in reverse! Computer remote controls should always be operated without mixer!