RBC kits JIMMY, Инструкция по сборке

Страница: 17 / 20

Building Instructions JIMMY Page van 17 20
Solder 2 mm dia. gold connectors to the
motor and ESC, and insulate with heat-
shrink tubing. Push the motor wires
through the opening in the firewall and
connect them to the ESC. Mount the
motor (without propellor!) to the firewall
with two screws, temporarily connect the
battery and check that the motor runs
counter-clockwise. If not, take the motor
off again, pull the connectors clear, swap
two of them and push them in again.
Mount the motor permanently with all
screws. Do not mount the propellor as
yet, see the ”Control Adjustments” chapter.
Use velcro to mount the battery onto
the battery carrier plate. This will allow
to mount the battery in various
positions to adjust the balancing point
(a.k.a. the Center of Gravity or CG) of
the plane.
The battery carrier plate remains
removable to simplify removing the
battery for charging, but the notches
in both sides lock into the bottom of
the opening in the main former to
keep it in place. The battery has to
be immobilised further with a piece
of foam of sufficient stiffness stuffed
into the opening of the main former.