24
Continued set up of the Spool Gun with RAZOR
145/210
(9)
Hold and snip the wire from the spool being sure to
hold the wire to prevent rapid uncoiling.
(10)
Carefully feed the wire over the drive roller into the outlet guide tube, feed through into the torch neck.
Check that the drive roller being used complies with the wire diameter, replace the roller if necessary.
(11)
Align the wire into the groove of the drive roller making sure the wire is in the groove of the drive
roller.
(12)
Apply a adequate amount of pressure to the drive roller by winding in the tension adjusting knob,
(13)
Adjust spool holder tension
(14)
Remove the gas nozzle and contact tip from the torch neck, Pull the trigger to drive the wire through
the neck until it exits the contact tip holder
(15)
Fit the correct sized contact tip and feed the wire through it, screw the contact tip into the tip holder of
the torch neck and nip it up tightly.
(16)
Fit the gas nozzle to the torch head and close the wire spool cover.
(17)
Carefully open the gas cylinder valve and set the flow rate to between 15 - 25 CFH.
(18)
Set the welding parameters using the wire feed and voltage control knobs.
(
18
)
(1
7
)
Carefully open the valve of the
gas
cylinder, set the
flow to between
21- 30 cfh. always "Crack" your cylinder
first and then adjust your flow
(1
0
)
Carefully feed the wire over the drive
roller into the outlet guide tube, feed
through into the torch neck.
(
1
0,11,12)
Align the wire into the groove of
the drive roller making sure the wire is in
the groove of the drive roller.
Apply a
adequate amount of pressure to the drive
roller by winding in the tension adjusting
knob,
(1
3
)
Adjust spool holder tension
, dont over
tighten
(1
4
)
Remove the gas nozzle and contact
tip from the torch neck, Pull the trigger to
drive the wire through the neck until it
exits the contact tip holder
(1
5
)
Fit the correct sized contact tip and
feed the wire through it, screw the
contact tip into the tip holder of the torch
neck and nip it up tightly.
(1
6
)
Fit the gas nozzle to the torch head
and close the wire spool cover.
(8)
Place the wire on the spool holder
, taking care to put the parts back on correctly
Set your welding parameters
using the wire speed knob and
the Voltage knob.
Содержание JRW145D
Страница 37: ...SPOOL GUN EXPLODED DIAGRAM SPGLBT200 37...
