RAZORBACK OFFROAD
™
5
Installation of the “IT FITS™” Support Arm
(STEP 2.1)
Place the hardware piece with the “IT FITS™”
Mounting Arm for the Adjustable Spare Tire
Mount against the location on the rack you wish
to install your “IT FITS™” Adjustable Spare Tire
Mount. At this time make sure that the facing of
the arm with the four circular holes and the single
large oval slot is facing upward.
STEP 2
(STEP 2.2)
Once the rack’s “IT FITS™” mounting bracket and
the “IT FITS™” Mounting Arm are aligned, inset a
single 1.4” x 3/4” Phillips/Slotted Screw into each
of the four holes on the “IT FITS™” Mounting
Arm, and then secure each screw with a single
1/4” Nylock Nut.
!
!
WARNING
Adding mounts to the side and/or rear of the vehicle
increases its size and may affect the balance and
performance of a vehicle. RBO does not recommend
installing the RBO1018 “IT FITS™” Spare Tire Mount
anywhere but at the tailgate location.
(STEP 2.3)
With the screws and bolts in place RBO recommends
using an impact driver with a #3 Phillips attachment
with a 7/16” wrench to tighten down the “IT
FITS™” Mounting Arm to the rack.
(FIG. 2.0)
(FIG. 2.1)
See Figure 2.0
See Figure 2.1
