RAZORBACK OFFROAD
™
11
(STEP 4.2)
Once the O ring is in place you may screw on the Lugnuts to completely secure the stud until you are
ready to mount your spare tire.
(STEP 4.1)
With the Stud and Nut holder in place slip a single 3/8” O ring over the studs threads on the opposite
side of the Tire Mount Plate and slid it down until it is touching the Tire Mount Plate. The 3/8” O ring
will then hold the stud in place within the slot preventing it from falling out but still allow for the lug
to be adjusted to fit multiple-Lug Hole positions.
(See Figure 4.3)
(FIG. 4.3)
WARNING
RBO recommends that when not transporting a spare tire that the Lugnut is always
used to secure the stud and O-ring. Reliance strictly on the O-ring only will
most likely result in the stud falling out and needing to be replaced.
!
!
THANK YOU AGAIN FOR CHOOSING RBO!
