RAZORBACK OFFROAD
™
8
(STEP 3.6)
The remaining cap screw, closest to Tire Mount
Plate, will need the single 1/4” Flat washer to be
installed on the underside of the arm before
adding the last remaining 1/4” Nylock Nut to
secure it in place
.
(FIG. 3.2)
(FIG. 3.4)
(STEP 3.4)
Continue to slide the Base Arm for Spare Tire
outward until the two holes on the side of the
Tire Mount Plate align with two holes on the “IT
FITS™” Mounting Arm. Once aligned inset, a
single a 1/4” x 3/4” Phillips/Slotted Screw into
three of the four holes on the “IT FITS™” Adjust-
able Spare Tire Mount’s Arms (One on Top and
two on the side).
See Figure 3.2
(STEP 3.5)
Place a 1/4” Nylock nut on the inside of the
channel and screw down each of the two screws
on each side of the arm and then tighten the
single screws closest on the top of the “IT FITS™”
mounting bracket using a single 1/4” Nylock Nut.
See Figure 3.3
(FIG. 3.3)
1
2
3
See Figure 3.4
(STEP 3.7)
With the screws and bolts in place RBO recommends
using an impact driver with a #3 Phillips attachment
with a 7/16” wrench to tighten down each Bolt and
nylock nut.
See Figure 3.3
