8
Starting the PowerRider 360
To start the unit, turn the power switch “ON”. Place both hands on the
handlebars and press the push button throttle.
Note:
Keep both feet on the foot pegs when unit is in motion.
Stopping the PowerRider 360
To stop the unit, release the push button throttle and apply the brake until the
unit comes to a complete stop.
USAGE
Throttle
Power
Switch
Brake
Throttle
REPAIR AND MAINTENANCE
Chain and Front Tire Replacement
Required Tools:
Phillips screwdriver, 10 mm wrench, two (2) 8 mm wrenches, 14 mm wrench and 17 mm wrench
1
Using a Phillips screwdriver,
loosen the two (2) screws located
on each side of the motor cover/
chain guard. Use an 8 mm wrench
to hold the lock nuts that keep the
screws in place.
6
Using 14 mm and 17 mm
wrenches, loosen the axle locknuts.
Push down and remove the wheel
from the fork. Remove the chain
from the front sprocket.
2
Using a Phillips screwdriver,
loosen the six (6) screws to remove
the motor cover/chain guard.
3
Remove the cable cap at the
end of the cable. (Do not lose.)
4
Using a 10 mm wrench, loosen
the brake cable anchor bolt and
disconnect the cable.
5
Using two (2) 8 mm wrenches,
remove the brake housing anchor
from the fork and brake plate. Keep
the bolt, washer and nuts together.
Disassembly
Turn power switch “OFF” before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power switch off
• Secure the unit under repair
• Exercise caution around
exposed parts
• Contact Razor customer service
if unsure about any repair or
maintenance
