8
1
Removal:
To remove a wheel,
remove the self-locking nut. Tap
the wheel to remove.
2
Front Wheel Installation:
Make sure the bearings are
properly seated and the center
spacer is installed. Position the
wheel with the
Razor logo
facing outward.
Install the
washer and tighten the self-
locking nut securely.
3
Rear Wheel Installation:
Make sure the key way is properly
seated in the rear axle and aligned
with the key way in the wheel.
Position the wheel with the
Razor
logo facing outward.
Install the
washer and tighten the self-locking
nut securely.
Note:
The Ground Force Drifter
Fury’s left wheel (Spark Bar handle
side) has additional hardware.
Note:
The Ground Force Drifter
Fury left wheel (Spark Bar handle
side) hardware sequence
Loosen
Tighten
Turn power switch off before conducting any maintenance procedures. Before you begin, carefully turn
unit upside down for easier access.
Replacing the Wheels
Tools Required:
13 mm wrench (front wheels), 17 mm wrench (rear wheels)
Front and rear wheel installation and removal are the same.
WARNING:
Failure to properly adjust and
tighten the screws, nuts and bolts
that affix the wheels can cause you
to lose control and crash.
Note:
The Ground Force Drifter Fury
wheels must be replaced when worn
down to the wear indicator line.
Note:
Practice drift riding only in
wide open areas clear from curbs,
parking blocks and other obstacles.
Impacting the wheels against
any hard surface can damage the
wheels. Wheels are not covered
under your limited warranty.
1
Using a 5 mm Allen wrench,
loosen the four (4) seat bolts and
remove seat.
4
Carefully turn unit over and
loosen the two (2) bolts next to the
brake cable.
2
Loosen the four (4) 5 mm bolts
(two on each side) on the battery
cover and remove cover.
5
Using a 10 mm wrench, loosen
the nut that holds the brake cable
and pull cable outward.
3
Remove the eight (8) bolts
(four on each side) that attach the
brackets to the frame.
6
Using a 5 mm Allen wrench,
loosen the four (4) bolts holding
the motor to the frame. Carefully
lower the motor and remove chain
from around the motor sprocket.
Removing Rear Axle
Tools Required:
5 mm Allen wrench, 10 mm wrench, 17 mm wrench
Turn power switch off before conducting any maintenance procedures.
REPAIR AND MAINTENANCE
Left Side (Spark Bar Handle)
12-1 Nut
12-2 Washer
Wheel
12-3 Key Way
12-2 Washer
26-5 Spacer (Small)
26-4 Rubber Washer
26-2 Washer (Large)
26-3 Spark Stone
26-2 Washer (Large)
26-1 Spacer (Large)
12-1
12-3
12-2
26-4
26-3 26-1
26-5
26-2
26-2
12-2
Содержание Ground Force Drifter Fury
Страница 2: ......
