7
Need Help?
Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at
www.razor.com
. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
REPAIR AND MAINTENANCE
Replacing the Spark Cartridge
Friction during sparking will eventually wear out the replaceable cartridge and cause the Ground Force Drifter Fury to
stop making sparks. Worn out cartridges must be replaced.
Tools Required:
Phillips screwdriver
Turn power switch off before conducting any maintenance procedures.
• Read the instructions
• Remove charger plug
• Turn the power switch off
• Secure the unit under repair
• Exercise caution around
exposed parts
• Contact Razor customer service
if unsure about any repair or
maintenance
WARNING:
Do not
attempt to replace cartridge
immediately after riding as cartridge
will be hot. Handle only when cool.
WARNING:
Keep fingers
clear of Spark Bar hinge.
WARNING:
Applying too
much pressure on the Spark Bar may
cause loss of control.
NOTE: Sparks and Spark
Cartridge life will vary based on
the amount of pressure applied
to the Spark Bar and the length
of time pressure is applied.
1
To adjust the brake, thread the
adjuster in or out 1/4 to 1/2 turns
until the desired brake adjustment
is attained.
2
If the adjuster is threaded
outward and the brake still has
too much slack, use the auxiliary
adjuster at the rear brake for
additional adjustments.
Note:
When properly adjusted,
the brake lever will have
approximately 3 mm of free play
before the brake engages.
Adjusting the Brake
Testing the Brake
To use the brake, squeeze the lever to increase the pressure on the brake. The brake lever is fitted with a cable
adjuster to compensate for cable stretch and/or to fine-tune the lever movement to brake engagement. If brake is not
engaging properly, follow instructions for adjusting the brakes.
WARNING:
Practice in an open area free from
obstacles until you are familiar
with the brake function. DO NOT
RUN OVER ANY OBJECT AS IT
COULD DAMAGE THE BRAKE OR
DRIVE TRAIN.
Note:
The brake lever contains
a safety switch to cut off power
to the motor when the brake
is applied. In an emergency,
applying the brake will always
stop the product from moving.
Do not disable or replace this
lever with anything other than a
genuine Razor replacement part.
1
Using a Phillips screwdriver,
loosen the screw on the spark
cartridge and remove the cartridge.
2
Install replacement cartridge
onto the Spark Bar and secure in
place with screw.
Содержание Ground Force Drifter Fury
Страница 2: ......
