Operating Instructions
e
LEG
www.Razorinternational.com
Page 6 of 8
CHARGER
The battery charger has three LED lights. For indication of the condition of the
battery and of power supply from the trailer their functions is as per the table
below:
CONTROLLER
To operate the legs you must first initiate (or wake up) the controller. This is
required to prevent the inadvertent or accidental operation of the legs which
could lead to hazardous and even dangerous situations.
You should also select the gear position you require. The high speed gear,
which is indicated by a
, is generally used to get the legs to the ground fast
and also return them to their home position (fully up) once they have cleared
the ground. The high load gear
, which is indicated by n
,
is generally used to
lift a loaded trailer once the legs are on the ground. The neutral position
,
indicated by ,
is only used if there is a problem and it allows you to still
manually wind the leg. (refer below)
To initiate the controller press and hold the
Stop button
for 2 seconds. The
Red LED
and
Yellow LED
will flash twice to acknowledge the controller has
been activated. It is noted that if the gear selection is in neutral you cannot
initiated the unit and you will get four
Red LED
flashes to indicate this
condition. First change the gear selection away from the neutral position
You may now operate in the legs in either direction by pressing the
down
(green) button
or the
up (blue) button.
The legs will continue to travel in the direction selected until the preset load
condition is met. If the legs are travelling down in high speed this will be when
the legs first hit the ground, if they are going up it will be when the legs reach
the end of their travel and are fully home. (Note: The Maximum run time is 2
minutes)
The gear selection lever is simple operated by rotating it by hand either to the
left or right. If the legs are operating and the gear selector is changed it will
stop the motor and the
Red LED
will illuminate while in the neutral position.
The drive can be restarted once either high load or high speed is selected.
The Controller has two LED lights for indication of the operation and the
battery condition their functions is as per the table below:
Red LED
This indicates that supply is connected
Yellow LED
This indicates that the battery is charging.
Green LED
This indicates that the battery is fully charged
