set-uP
q
Charging the Battery
Your Electric Wagon may not have a fully charged battery; therefore you must charge the battery prior to use.
• Initial charge time: 12 hours
• Run time: up to 40 minutes
• Recharge time: up to 8 hours
• Average battery life: 250 charge/discharge cycles
• Fully charge once a month when not in use
• Do not store below 32 degrees - this can damage the battery.
1
Align the groove on the charger
port with the corresponding tab
on the Electric Wagon socket and
insert into socket.
Note:
The charger works with the
power switch in either the on or off
position.
2
Plug the charger plug into a
wall outlet.
warning:
Rechargeable batteries are only to
be charged under adult supervision.
Always disconnect your Electric
Wagon from the charger before
cleaning with liquid.
Note:
If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with an LED to indicate the charge
status. Refer to the illustration
on the charger unit for the actual
“charging” and “charged” status
indications for your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Be sure to properly align the
groove on the charger port with
the corresponding socket on the
body; otherwise, no charging
action will occur.
Charger
Plug
Charger
Port
q
Assembling the Wagon
1
Position the Wagon with
the body up side down on a flat
surface.
2
Insert the rear axle into the
hole in the gearbox and slide it
through to the other side.
3
Locate the 2 rear wheels
(Rear wheels have gears on the
inside). Slide one wheel over
the axle until it interlocks with
gearbox.
4
Insert a fixed clip into the clip
tool.
5
Position the fixed clip and
clip tool over the end of the
axle. Using a rubber mallet/
hammer, strike the tool to
securely attach the clip onto the
rear axle.
3
