razberi technologies
™
8
2. Camera
Cabling
Please follow the instructions below to complete IP Camera connection.
2.1 Connect
Power
Please refer to
Section: Connectors
. Alternatively, connect the Ethernet cable to
the camera’s PoE port and plug the other end of the cable into a PoE switch.
NOTE:
If using PoE, make sure Power Sourcing Equipment (PSE) is in
use in the network.
2.2
Connect Ethernet Cable
Use of Category 5 Ethernet cable is recommended for network connection; to
have best transmission quality, cable length shall not exceed 100 meters.
Connect one end of the Ethernet cable to the RJ-45 connector of the IP Dome
Camera, and the other end of the cable to the network switch or PC.
NOTE:
In some cases, you may need use an Ethernet crossover cable
when connecting the IP Dome Camera directly to the PC.
Check the status of the link indicator and activity indicator LEDs; if the LEDs are
unlit, please check LAN connection.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
2.3
Connect Alarm I/O
The camera equips one alarm input and one relay output for alarm application.
Refer to alarm pin definition below to connect alarm devices to the IP Camera if
needed.
PIN 1: GND (Input-)
PIN 2: Input+
PIN 3: Output-
PIN 4:
Содержание DV200
Страница 1: ...Full HD Multi Stream Vandal Proof Dome IP Camera DV200 DV200L DVO200 DVO200L User Manual Ver 4 17 ...
Страница 18: ...razberi technologies 17 352 x 240 30fps ...
Страница 46: ...razberi technologies 45 ...
Страница 77: ...razberi technologies 76 Step 3 Click on the button to save the defined preset point ...