22
rayteccctv.com
Raytec Global Tel: +44 (0) 1670 520055
Americas Tel: +1 613 270 9990
PIN Function Detail
The PIN is set by using the Vario
Remote Control (VRC). There are
five buttons / characters on the
remote that can be used for this
purpose. They are Power 5, Power
1, Min Photocell (Smallest moon),
Max Timer (Full Red Circle) & Timer
Disable (Timer Circle image with a line
through). Note – invalid characters will
not be recognised.
To create a PIN, press STATUS
BUTTON for 4 seconds. LHS LED will
flash RED/GREEN. This indication will
always show that you are in PIN mode.
RHS LED FLASHING RED shows you
are in PIN set mode. The number of
flashes indicates how many characters
are required to complete the PIN
entry. There are four characters to be
entered to successfully set up a PIN.
As you enter the characters, the number of flashes will decrease until all characters
are entered. Note, illegal characters will not be recognised and will not reduce the
number of flashes. When the PIN is set the illuminator will revert to Programming
Mode.
When a PIN is Set :
Using the remote you can access the illuminator settings from operating mode by
entering the PIN.
You cannot access Programming Mode by power re-cycling only.
In operating mode, if you want to go back into programming mode simply enter
your PIN. To do this, press STATUS BUTTON for 4 seconds. LHS LED will flash RED/
GREEN to show you are in PIN mode. RHS LED FLASHING GREEN shows that a
PIN has been previously set. As you input the four correct characters the number of
flashes will reduce and you will be returned to programming mode.
If legal characters but not the correct sequence of characters is entered the number
of flashes will still reduce and after 4 characters have been entered an error will be
shown by both LED`s flashing RED.
NOTE
: If you forget your pin and
need to make adjustments to the
illuminator you need to do full Re-set.
This requires power recycling whilst
pressing the two manual control
buttons at the same time. This will
restore factory default settings AND
remove the previously programmed
PIN. Both LEDs will flash AMBER to
signify that the process has been
completed.
NOTE
: If you need to check if a PIN
is set up, in Operating Mode hold the
status button down for 4 seconds and
both LEDs flash RED, this means there
is no PIN present.
