Raytec VARIO 2 VAR2-i8-3, Быстрый старт, Страница: 2 / 32

Wiring:
1. Mount Illuminator
2. Connect Illuminator to low voltage input 12-24V AC/DC
IMPORTANT: For Vario 16 variants : 24V only AC/DC
3. Complete configuration, wiring and final set-up using manual push buttons on
the illuminator or VARIO Remote Controller (VRC) - VRC is an optional
accessory
Black Wire = Negative (+ve)
Red Wire = Positive (-ve)
White & Yellow wires = Photocell following contact, Volt free output, Non polarity
sensitive
Orange and Purple Wires = Telemetry input Volt free / dry contact or TTL input
Lens Selection:
VARIO is factory set and delivered with a N beam width angle.
+=/:B3@B=NA7;>:G remove interchangeable lens (ILS).
+=/:B3@B=N@3>:/13E7B6=B63@!#*:3<AAC>>:732
&B63@/<5:3!#*:3<A3A/@3/D/7:/0:3B==@23@N/<2N
Please handle ILS lenses with care – and do not touch optical film.
Use 2.5mm Allen/hex key. Re-attach base plate securely ensuring gasket is correctly
located.
Important Note : Ensure base plate is securely located, the gasket is
correctly located and the screws correctly fastened to ensure and
maintain IP66 rating of the product