Raytec VARIO 2 VAR2-i8-3, Быстрый старт

Страница: 19 / 32

((
To delete an existing PIN you first need to be in Programming Mode by
entering your PIN. Once in Programming Mode, press STATUS BUTTON for
4 seconds to go into PIN set mode. LHS LED will flash RED / GREEN and
RHS LED FLASHING RED. Instead of entering one of the known legal
characters press the RESET BUTTON four times. The illuminator will return to
programming mode. Note – if you delete the PIN and the illuminator
times out into operating mode, you will not be able to go back to
programming mode without recycling the power.
*Note - If you forget your pin and need to make adjustments to the
illuminator you need to do full Re-set. This requires power recycling whilst
pressing the two manual control buttons at the same time. This will restore
factory default settings AND remove the previously programmed PIN.
Both LEDs will flash AMBER to signify that the process has been
completed.
*Note – If you need to check if a PIN is set up, in Operating Mode hold
the status button down for 4 seconds and both LEDs flash RED, this means
there is no PIN present.