Raypak 408, Инструкция по установке и эксплуатации

Страница: 26 / 40

26
Set Factory Defaults
Refer to step one above to access the program screen. Set
Factory Defaults should appear on the screen. If it does
not, press the MENU/SET button until it appears on the
digital display. Press and hold both UP and DOWN buttons
for 5-7 seconds until Defaults Set appears. This operation
resets the operating program to its factory default values.
Both the POOL and SPA setpoints will revert to 65°F (18°C)
and both POOL and SPA maximum temperature settings
will be 104°F (40°C). The Control Lockout PIN will be
cleared and the control will resume normal operation.
Clear Faults
Refer to step one above to access the program screen.
Press the MENU/SET button until Clear Faults appears
on the digital display. Press and hold both UP and DOWN
buttons for 5-7 seconds until Faults Cleared appears. This
operation resets the Fault History file to “0” and clears all
the stored faults.
Fahrenheit or Celsius
Refer to step one above to access the program screen.
Press the MENU/SET button until Fahrenheit or Celsius
appears on the digital display. The UP or DOWN buttons
will select Fahrenheit or Celsius on the temperature
display. Choose the desired temperature scale.
Spa Max Temp – Spa Set Point Maximum Adjustment
Refer to step one above to access the program screen.
Press the MENU/SET button until Spa Max Temp appears
on the digital display. Using the UP and DOWN buttons
will change the Maximum Temperature Setting to your
desired value. The control can be set for a maximum of
107°F (42°C).
Pool Max Temp – Pool Set Point Maximum
Adjustment
Refer to step one above access into the program screen.
Press the MENU/SET button until Pool Max Temp appears
on the digital display. Using the UP and DOWN buttons
will change the Maximum Temperature Setting to your
desired value. The control can be set for a maximum of
107°F (42°C).
8.3.3. Control Lockout
The heater is equipped with a Control Lockout feature
to prevent unauthorized tampering or adjustment of the
control settings. To lock out the controls, press the DOWN
button and MENU/SET button for 5 seconds. Choose a
three digit PIN, using the UP and DOWN buttons to select
the digits and the MENU/SET button to lock in selections.
Confirm your selection and record your PIN.
To unlock the controls, press any button to bring up the
Enter PIN menu. Enter the PIN that was used to lock the
control. Note that power cycling will not clear the lockout.
Successfully unlocking the control will display “Lockout
Cleared.” Failure to enter the correct PIN will display
“Invalid PIN.”
In the event that the user-selected PIN is lost or does not
clear the Control Lockout, use the Program Button to Set
Factory Defaults. This will clear the PIN and allow normal
operation and selection of a new PIN if desired.
NOTE: Both the POOL and SPA setpoints will revert back to
65°F (18°C) and the POOL and SPA maximum temperature
settings will be 104°F (40°C). These setpoints will need to
be readjusted to desired settings.
NOTE: The LCD temperature display may not agree with
the temperature reading of your pool or spa thermometer.
The heater reads the water temperature at the inlet. Due
to the circulation characteristics of any pool or spa, the
water temperature at the inlet to the heater may differ
from that observed at a given location in the pool or spa.
8.4. Status and Diagnostics
The digital thermostat models are programmed to display
a variety of status and diagnostic messages, depending
on the operating conditions.
The following heat status messages are displayed in Pool,
Spa, and Remote modes when there are no active fault
conditions.
Display Condition
Heating Call for heat established, flame present.
Spark Spark operating.
No Demand Heat demand is satisfied.
Table K. Heat Status Messages - No Active Faults