Raymarine ST60 Tridata, Руководство пользователя

Страница: 48 / 54

36 ST60 Speed Instrument Owner’s Manual
9. Carry out a second calibration run (see sheet 2 of the Speed calibra-
tion flow chart), using the procedure described above in steps 4 to 8.
Note: At the end of this second run, the text END alternating with the new
calibration factor is displayed at the top of the screen.
10. Press the
speed
key to leave speed calibration and return to the
Instrument status screen.
Leaving Intermediate calibration
Hold down the
speed
and
trip
keys for 2 seconds to save your settings,
exit Intermediate calibration and resume normal operation.
4.4 Dealer calibration
The Dealer calibration procedure (see Dealer calibration diagram)
enables the following parameters to be set:
• User calibration on/off.
• Speed response.
• VMG response.
• Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen. This
enables you to re-apply the factory settings if you want to reset the
instrument to a known operating condition.
To commence Dealer calibration, hold down the
speed
and
trip
keys
together for approximately 12 seconds, to select the Dealer calibration
entry page. Press the
timer
and
reset
keys together, to proceed with the
calibration, then use the
speed
key to proceed from screen to screen as
calibration progresses.
User calibration on/off
Press the
timer
or
reset
keys to toggle the User calibration either
ON
or
OFF
as required. With
OFF
selected, User calibration and Intermediate
calibration are both disabled.
PDF test 81037_4.book Page 36 Friday, July 26, 2002 11:08 AM