Raymarine ST60 Tridata, Руководство пользователя

Страница: 16 / 54

4 ST60 Speed Instrument Owner’s Manual
Trip
The trip distance is reset at power up and may also be reset manually, by
pressing the
reset
key for 3 seconds. The display shows the distance
covered since the last reset.
Note: The trip distance can be reset only if the instrument is a master,
i.e. connected to a speed transducer.
Water temperature
The water temperature is shown in either degrees Celsius or Fahrenheit,
as set during calibration (see
Chapter 4, Calibration ).
Timers
The
timer
key gives access to a count-up timer and to two race-start
timers. Times are either in seconds (
S
) or minutes (
M
), depending on the
counter values.
Refer to the Using timer key flow diagram to display the required timer.
Once you have selected the required timer display, press the
reset
key to
start the timer running. When a timer is running, the delimiter (i.e. ‘.’or
‘:’) flashes. For lap timing, press the
reset
key. To stop and reset a timer
to the start value, hold down the
reset
key for 1 second.
Once a timer is running, you can leave the timer page and select any other
display. The counter will continue to run in the background.
Race-start timers
You can set each race-start timer to any whole-minute value from 1 to 15
minutes.
Note: When the instrument is first installed, the race-start timers are set
to 4 and 5 minutes respectively.
To set a race-start timer:
1. Use the
timer
key as shown in the Using timer key flow diagram to
select the required race-start timer.
2. Simultaneously press the
timer
and
reset
keys to enter the race-start
timer adjust mode.
3. Use either the
timer
or
reset
key to set the required value.
4. Simultaneously press the
timer
and
reset
keys to save the value and
leave the race-start timer adjust mode
PDF test 81037_4.book Page 4 Friday, July 26, 2002 11:08 AM