Raymarine i50 Depth, Инструкция по установке и эксплуатации

Страница: 22 / 90

3.7 Product dimensions
D12389-1
A C G
D E
B
F
A 110 mm (4.22”)
B 115 mm (4.52”)
C 14 mm (0.55”)
D 30 mm (1.18”)
E 35 mm (1.38”)
F 90 mm (3.54”)
G 17 mm (0.67”)
3.8 Selecting a transducer location
General speed and depth transducer location
requirements
When selecting a location for your transducer it is
important to consider a number of factors.
The transducer should be mounted within the clear
water flow areas indicated by the shaded areas in
the image below.
D 4349-2
1
2
3
1 Sailing vessel
2 Planing power vessel
3 Displacement power vessel
Each transducer should also:
• Be ahead of the propellers (by a minimum of 10%
of the water line length).
• Be at least 150 mm (6 in) away from the keel
(ideally ahead of the keel on a sailing yacht).
• Be as near as possible to the center line of the
vessel.
• Be clear of other through-hull fittings or projections.
• Have sufficient clearance inside the hull to fit the
nut.
• Have 100 mm (4 in) of headroom to allow for
withdrawal.
Note: In addition to the above requirements, the
depth transducer must be mounted within 10º of
the vertical.
D4350-5
22 i50