Raymarine AXIOM 2 XL, Руководство по установке

Страница: 67 / 108

Possible causes Possible solutions
Damaged cables 1. Check the unit’s connector for broken or bent
pins.
2. Check that the cable connector is fully inserted
into the unit and that the locking collar is in the
locked position.
3. Check the cable and connectors for signs of
damage or corrosion, replace if necessary.
4. With the unit turned on, try flexing the power
cable near to the display connector to see if this
causes the unit to re-boot/loose power, replace
if necessary.
5. Check the vessel’s battery voltage, the
condition of the battery terminals and power
supply cables, ensuring connections are
secure, clean and free from corrosion, replace
if necessary.
6. With the product under load, using a
multi-meter, check for high voltage drop across
all connectors/fuses etc (this can cause the
Sonar applications to stop scrolling or the unit
to reset/turn off), replace if necessary.
Vessel speed too
high Slow vessel speed and recheck.
Bottom too shallow
or too deep The bottom depth may be outside of the transducers
depth range, move vessel to shallower or deeper
waters as relevant and recheck.
Poor / problematic image
Possible causes Possible solutions
Vessel stationary Fish arches are not displayed if the vessel is
stationary; fish will appear on the display as straight
lines.
Scrolling paused or
speed set too low Unpause or increase sonar scrolling speed.
Possible causes Possible solutions
Sensitivity settings
may be inappropriate
for present
conditions. Check and adjust sensitivity settings or perform a
Sonar reset.
Damaged cables 1. Check the unit’s connector for broken or bent
pins.
2. Check that the cable connector is fully inserted
into the unit and that the locking collar is in the
locked position.
3. Check the cable and connectors for signs of
damage or corrosion, replace if necessary.
4. With the unit turned on, try flexing the power
cable near to the display connector to see if this
causes the unit to re-boot/loose power, replace
if necessary.
5. Check the vessel’s battery voltage, the
condition of the battery terminals and power
supply cables, ensuring connections are
secure, clean and free from corrosion, replace
if necessary.
6. With the product under load, using a
multi-meter, check for high voltage drop across
all connectors/fuses etc (this can cause the
Sonar applications to stop scrolling or the unit
to reset/turn off), replace if necessary.
Transducer location • Check that the transducer has been installed in
accordance with the instructions provided with
the transducer.
• If a transom mount transducer is mounted too
high on the transom it may be lifting out of the
water, check that the transducer face is fully
submerged when planing and turning.
Transducer
kicked-up If the transducer has a kick-up mechanism, check
that it has not kicked up due to hitting an object.
Troubleshooting
67