Raymarine AXIOM 2 PRO, Руководство по установке

Страница: 47 / 126

6. Marine grade sealant.
7. Pozi-drive screwdriver.
8. 7 mm wrench or small adjustable wrench.
9. Drill bit 3.7 mm (
5
/
32
”) for fixing holes.
Rear access requirements
Access to the rear of the display and mounting surface is required to surface
and flush mount the display.
Ensure there is sufficient access and space behind the mounting surface to
attach and tighten the fixings and also to connect the cables.
Preparing the mounting surface — surface mounting
Surface mounting requires one cut-out hole. When the display is surface
mounted, the glass/bezel will protrude from the mounting surface.
Note:
The following procedure is for preparing the mounting surface for
surface mount installations. For flush mounting details, refer to:
p.44 — Preparing the mounting surface — flush mounting
Note:
Before preparing the mounting surface, ensure that:
• your selected location meets the location requirements. For details refer
to: p.33 — Location requirements
• you have identified cable connections and the route that the cables
will take.
1. On the mounting surface, mark the Cut-out line identified on the supplied
mounting template
2. On the mounting surface, mark the 4 fixing screw hole locations identified
on the supplied mounting template.
3. Use a drill and an appropriate size drill bit or hole cutter to cut out the
corners of the Cut-out line.
The corner diameters for the displays are:
• 33.00 mm (1.30 in) — Axiom® 2 Pro 9.
• 37.00 mm (1.47 in) — Axiom® 2 Pro 12.
• 38.00 mm (1.5 in) — Axiom® 2 Pro 16.
4. Use a jigsaw or similar cutting tool to cut out the remainder of the cut-out
area.
5. Drill the 4 fixing holes at the marked location using a 3.7 mm ( 5 /
32
”) drill bit.
6. Use a half round file and/or sandpaper to smooth and rough edges or
burs on the cut-out hole.
Installation 47