Raymarine AXIOM 2 PRO, Руководство по установке

Страница: 46 / 126

1. Ensure you have followed the instructions for preparing the mounting
surface for flush mounting.
2. Route the relevant cables to behind the mounting surface cut out..
This may be difficult or not possible once the display has been mounted.
3. Remove the backing from the supplied gasket and place the sticky side
of the gasket onto the flange on the rear of the display and press firmly
onto the flange.
4. Connect the relevant cables to the rear of the display.
5. Slide the display into the cut out area.
6. Pull back the 3 corner bungs and open the card reader door.
7. Insert the fixing bolts, attach the washers and nuts from the rear and
tighten.
8. Close the 3 corner bungs and the card reader door.
Note:
The supplied gasket provides a seal between the display and a suitably
flat and rigid mounting surface or binnacle. The gasket should be used in
all installations. It may also be necessary to use a marine-grade sealant if
the mounting surface or binnacle is not entirely flat and/or has a rough
surface finish.
8.6 Surface mounting
Tools required (surface mount installations)
The following tools are recommended for surface mount installations:
1. Power drill.
2. Hole cutter (appropriate size for corner diameters of the Cut out line
identified on the supplied mounting template):
• 33.00 mm (1.30 in) — Axiom® 2 Pro 9.
• 37.00 mm (1.47 in) — Axiom® 2 Pro 12.
• 38.00 mm (1.5 in) — Axiom® 2 Pro 16.
3. Jigsaw.
4. Half round file (or sandpaper).
5. Masking/self adhesive tape.
46