Raymarine Autohelm ST3000, Руководство пользователя

Страница: 63 / 77

58 ST3000 Wheel Drive Autopilot - Owner’s Handbook
5
Co
mmi
ssi
oni
ng
th
e W
heel
P
ilo
t
Heading alignment
1. Steer your boat on a straight course, then use
-1
and
+1
to adjust
the displayed autopilot heading until it agrees with the boat’s
steering compass or a known transit bearing.
2. Exit compass linearization and heading alignment and store the
compass correction/alignment values as follows:
•
press and hold
STANDBY
for 1 second until the pilot beeps
• or, to exit without saving any new settings, press
STANDBY
momentarily
Note: For installations where an ST50 or ST30 Steering Compass
instrument is connected to the SeaTalk bus, and the Steering
Compass has a fluxgate transducer connected, it is only necessary to
carry out the auto deviation correction on the Steering Compass
Instrument (refer to Steering Compass handbook instructions).
Further adjustments to heading alignment
If the heading alignment requires further adjustment after the initial
sea trial:
1. Enter Compass Deviation Correction by pressing
STANDBY
for
1 second.
2. Press
AUTO
to skip Deviation Correction and proceed to Heading
Alignment.
3. Adjust the heading as described above.
4. Press and hold
STANDBY
for 1 second to save changes and exit.
Autopilot operation
Having calibrated the compass, the following procedure is
recommended to familiarize yourself with autopilot operation:
1. Steer onto a compass heading and hold the course steady.
2. Engage the wheel drive clutch by rotating the clutch lever
clockwise.
3. Press
AUTO
to lock onto the current heading. The wheel pilot
should achieve a constant heading in calm sea conditions.
4. Use the course change keys to alter course to port or starboard in
multiples of 1° and 10°.
5. Press
STANDBY
and disengage the clutch lever to return to hand
steering.
81194_1.book Page 58 Wednesday, July 25, 2001 12:10 PM