Raymarine 37STV Gen2, Дополнительные инструкции по установке и эксплуатации

Страница: 20 / 20

You can connect two IRDs to your antenna as shown in the diagram.
In this system, one IRD can be set as a two satellite receiver. The
other IRD must be set as a one satellite receiver.
The RF connection into the IRD is usually made into the connector
labelled
LNB , ANT , or Satellite In .
Refer to the relevant Manufacturer’s handbook for details on
configuring your IRD.
System with 4 IRDs
You can connect four IRDs to your antenna as shown in the
following diagram.
IRD1 (not supplied)
ANT RF1
FUSE NMEA PC INTERF ACE
RECEIVER
- +
- +
MADE IN KOREA
RF 2 RF 1
RF 4 RF 3
IRD2 (not supplied)
RF cable
Antenna base plate
ACU
IRD3 (not supplied)
IRD4 (not supplied)
DC 9 to 30V
Power in
D1
1
548-2
The RF cables from the antenna base plate connect to either the
LNB , ANT , or Satellite In connector on the rear of the IRD.
Refer to the relevant Manufacturer’s handbook for details on
configuring your IRDs.
20
STV Gen2 installation and operation