55M4300CCE00 Rev A
Additional winch geometry
Alternative location of hoist
drums using guide sheaves on
boom. All dimensions in the
previous sketch are still
required, note dimensions
cl6a
and
cl6m
are normally
negative in this case.
Step #6: “Block capacities and block weights” setting
This menu contains the capacities and weights of all the available hooks for the crane,
the hook(s) in use must be entered here for subsequent selection in the configuration
setting of the system. The capacity of each hook will be used by the i4300 system to
determine whether the current SWL for the configuration and position of the machine is
limited by the load curve, the parts of line or the hook capacity. The weight of the
selected hook will be used in the calculation of the load if set as an ‘unused hook’ in the
duty wizard, refer to operation manual.
After selecting “block capacities and block weights” from the main calibration menu the
screen will show:
Set the capacity and weight of each hook block in turn using the calibration units set
earlier (noted at the bottom of this screen). Remember to press
“save”
once all the
data is entered. Numbers shown are for illustration purposes only and must be set to
show real data from the machine.
