T415 Operation & Service Manual
62
Maintenance
Phone: 608-365-2563
11
Fax: 608-365-2182
INPUT SEAL
Figure G
Figure H
6) Press in the two (2) dowel pins to insure proper
alignment. Evenly install and tighten the cap
screws. Refer to Table 1 (see page 33) for proper
torque specifications.
7) Turn over the assembled gear box to install the
input seal. Apply a small coat of oil to the gear surface
to allow the seal to properly seat. Apply a thin coat of
Loctite 609 to the seal O.D. and press into place, .060”
below flush with the gear. Pressing the seal too far
will create a leak or possibly block oil to the bearings
(see Figure H).
Do not use sharp objects for pressing in
seals. Press only on the outer edge of the seal to keep
from bending or damaging the seal casing.
8) To install the dipstick, upright the gear box. Apply
Loctite 609 to the dipstick tube and insert the dipstick tube
until the expanded neck bottoms out on the gear box
housing. In all cases (except 1PD06) make certain that the
second hole is plugged with a 012326 expansion plug.
Note that the 1PD06 has only one dipstick location on the
left side.
CAUTION