T415 Operation & Service Manual
60
Maintenance
Phone: 608-365-2563
9
Fax: 608-365-2182
7) Evenly lift the output housing half, being careful not
to lift any of the gears. Inspect the gears and bearings
for any defects, wear, or contamination before
removal. To remove the gears and bearings, swiftly
and evenly lift from the housing. This can be done by
hand as the bearings are a slip fit (see Figure C).
When rotating gears keep hands and
fingers clear from the gear mesh.
8) With all of the gears removed, drive the input
seal out towards the engine adapter. It is required to
change the input seal any time the input gear has been
removed from the housing.
9) To remove the bearings from the gears, use a gear
puller or Arbor press (see Figure D).
NOTE: Bearings MUST be replaced any time they have
been removed from the gear.
WARNING
Figure C
Figure D