Raychem HTC-915, Руководство пользователя, Страница: 7 / 8

POINT SETUP SUB-MENU
Parameter Factory User
Tag TAG-(factory ID)
Switch Control Mode Deadband
Deadband 5°F (3°C)
Prop Band *n/a (4°F (2°C))
Cycle time *n/a (10 min)
Switch Rating *n/a (30.0 A)
Circuit Breaker *n/a (30.0 A)
Outlet Limit Mode Disable
Max. Power *n/a (7200 W)
Max. Current *n/a (30.0 A)
3 Ph Pwr Calc No
TS Fail Mode Off
TS CTL Mode TS1-Fail Off
TS 1 Hi Limit *n/a Disable
TS 2 Hi Limit *n/a Disable
Volt Turns Ratio 1.00 to 1
Current Turns Ratio 1.00 to 1
Auto-cycle Enable
Auto-cycle Interval 8
Auto-cycle Units Hours
Override Source Remote
Load Shedding *n/a
Limiter Cutout Temp. *n/a (50.0°C)
Limiter Current Sense *n/a (Disable)
MISC. SETUP SUB-MENU
Parameter Factory User
Temp. Units °C n/a
Version V1.0X.XX
Limiter version *n/a (V1.0X.XX)
Ext. Input Not used
Flash Alarm Output Yes
Alarm output N.C.
Language English
Passcode 0
Scroll Delay 0.15 secs
Load Defaults (See user manual)
Limiter Installed No
COMMUNICATION SETUP SUB-MENU
Parameter Factory User
Protocol Modbus RTU
Modbus Addr *n/a (1)
Modbus Sub Addr *n/a (0)
Baud Rate Auto
Parity *n/a (None)
Tx Deley 0.06 secs
* n/a: Parameter may only appear if certain features are
enabled. Values shown in brackets are the Factory defaults
if the settings are enabled.
This information defines the default 915 Series Control
Module configuration as set by the Factory for firmware
V1.0X. These settings are subject to change without notice.
It is the user’s responsibility to verify that all configuration
parameters are chosen appropriately for the intended
application.
OTHER ALARMS CONFIGURATION SUB MENU
Parameter Factory User
Lo Load Enable
Lo Load 1.0 A
Lo Load Filter 0 sec
Hi Load Disable
Hi Load *n/a (30.0 A)
Hi Load Filter *n/a (0 sec)
Hi GFI Enable
Hi GFI 20 mA
Hi GFI Filter 0 sec
GFI Trip Enable
GFI Trip 30 mA
Lo Volt Enable
Lo Volt 90 V
Lo Volt Filter 0 sec
Hi Volt Disable
Hi Volt *n/a (270 V)
Hi Volt Filter *n/a (0 sec)
Lo Resist Disable
Lo Resist *n/a (50%)
Lo Resist Filter *n/a (0 sec)
Hi Resist Disable
Hi Resist *n/a (50%)
Hi Resist Filter *n/a (0 sec)
Nominal Resist *n/a (6.00 Ω)
Overcurrent Trip *n/a (Enable)
Switch fail Enable
HTC Reset Disable
C.B. Limiting *n/a (Disable)
Output Limiting *n/a (Disable)
Switch Limiting *n/a (Disable)
Contactor Count Enable
Contactor Count 200,000
EEROM data Fail Enable
nVent.com | 7