Rayburn Heatranger 480CD, Руководство по установке

Страница: 15 / 24

EXHAUST DUCT
THIS APPLIANCE MUST BE INSTALLED WITH THE
DUCTS AND TERMINALS SUPPLIED.
l
It is recommended to fit the spigots to the appliance
before putting it into position for ease of fitting.
l
Locate and secure 100mm air inlet spigots, 1 gasket
and 4 screws. (See Fig. 11). It is advisable to stick the
gaskets to the appliance using a sealant to ease the
fitting.
l
Screw in tap tight screws to secure spigots.
l
Using Fig. 12, measure from the outside of the wall to
the end of the recess on the 100mm spigot, this will
be the same for both the cooker and boiler flues, then
cut the 100mm tube to this length. Then cut the 60mm
pipe to 120mm. (See Fig. 13).
Once both flues have been cut to size, file any burrs away
and chamfer the 60mm pipe ends to allow easier fitting
into the couplings.
N.B. It may also be possible to use a high temperature
grease to allow easier fitting.
To ensure the boiler flue has been fitted correctly into
the boiler flue outlet, remove the glass control facia and
brackets behind. The boiler elbow can then be adjusted if
required and a correct fitting can also be checked of the
flue. The covering plate supplied can then be mounted on
the wall.
TERMINAL GUARD
l
Locate terminal guard to wall, mark location of
securing holes, remove guard.
l
Drill holes and fit rawlplugs.
l
Locate and secure terminal guard to wall (4 screws).
NOTE: The guard must be fitted where the terminal is
below 2m above the ground level or where the terminal
can be touched either intentionally or accidentally eg.
window cleaning or painting.
15
Balanced Flue Installation
Fig. 11 DESN 514867
Fig. 12 DESN 514868
Fig. 13 DESN 514869 A
Fig. 14 DESN 514870