If a fault occurs on either burner then a fault code is
displayed and shuts down the part of the appliance with a
fault (cooker or boiler).
This can be re-set after 1 minute, by pressing the
REPEAT button.
In the event of repeated failure switch off the gas and
electrical supply to the appliance and contact the
installer/service engineer.
If a gas leak or fault exists or is suspected, the unit must
be isolated from the gas and electricity supply. The
appliance must not be used until the fault has been
rectified.
Advice/help should be obtained from the
installation/servicing company.
In the event of power failure the appliance will become
inoperative. When the power is restored, it will
automatically restart, if programmed or manually set to do
so.
With normal use a boiler/cooker annual servicing should
be carried out by a qualified engineer, preferably at the
start of the heating season.
NOTE: ENSURE THAT THE HOTPLATE HAS BEEN
RE-FITTED CORRECTLY, AS THIS FORMS PART OF
THE COOKER COMBUSTION CIRCUIT.
A HOT APPLIANCE CANNOT BE SERVICED.
Both cooker and boiler thermostat knobs should be turned
OFF the night preceding the day of the servicing so that
the appliance will have cooled down by the following
morning.
Should a problem arise with the cooker or boiler, an alarm
or an error code fault will be displayed, on the RH side for
the cooker and the LH side for the boiler.
11
DESN 514723
BURNER RE-SET
GAS LEAK OR FAULT
POWER FAILURE
SERVICING
Fig. 10
FAULT INDICATOR
