Ravenheat HE 85 A, Инструкция по установке и обслуживанию

Страница: 17 / 54

Supplied By www.heating spares.co Tel. 0161 620 6677
18
5.4 POSITIONING OF THE BOILER
5.4.1 - Remove the 2 screws that secure the upper
part of the front panel of the casing (Fig 19).
- Carefully slide the front panel a few millimetres
up towards the top of the appliance until it is
free from its slot, and then lift off (Fig. 20).
5.4.2 Unscrew the 2 screws that fasten the lower
grating on the casing and remove it from the
sides of the casing (Fig. 22)
5.4.3 Push down the 2 plastic clips that fasten the
instrument panel (Fig. 23).
5.4.4 Lower the instrument panel down by rotating it
on its own hinges (Fig. 25)
Unscrew the two screws fastening panels (Fig.
21).
5.4.5 Remove the two sides of the casing by slightly
lifting them and carefully sliding towards the
top of the appliance, to release them from their
upper suspension hooks (Fig. 26-27)
5.4.6 Make sure the casing and screws are put to
one side in a safe place.
5.5 INSTALLING THE APPLIANCE FOR REAR
FLUE OUTLET
5.5.1 Use adhesive tape to attach the template to
the wall, making sure that the centre line is
vertical.
- Mark the four boiler fastening holes on the
wall as well as the centre of the flue duct
- Detach the template from the wall.
- Use a 10 mm. dia drill to make the 4 boiler
securing holes. Insert the plastic expansion
plugs.
- Cut or core drill a 105 mm. dia hole for
inserting the flue duct
- Screw in the two upper coach bolts leaving
them about 10 mm. out from the wall to
enable the boiler to be located on the wall
Fit the elbow header positioning it towards the
required direction (Fig 30).
IMPORTANT:
Make sure that the elbow’s dia.
60 mm duct is inserted into the fan, the rubber
seal and
orifice (F2) have been correctly
fitted.