Raven OmniSeed Viper Pro, Калибровка и руководство по эксплуатации

Страница: 49 / 308

4
Manual No. 016-3001-015 Rev. C 37
Initial Set Up and Navigation
Initial Set Up
The first time the Viper Pro is powered up, the field computer will require the operator to input information
about the machine and the type of applications, products and setup any additional features connected to the
system. The following sections are provided to assist the operator in setting the required calibration information
prior to starting an actual application with the Viper Pro system.
During initial set up of the field computer, the following settings will be configured:
The above settings are the standard settings which the Viper Pro requires to monitor and control product
application. Depending upon additional features installed with the field computer or application types which the
Viper Pro may be used to control, additional settings may be required. Refer to Chapter 7,
Advanced Settings
and Features for additional information on product control settings and features.
Language
To select the language displayed on the Viper Pro field computer:
1.
Touch Menu , Setup , Local and Lang. The Language Setup screen will be displayed.
2.
Touch the desired language for display on the field computer and select OK to return to the main screen.
Time Zone
1.
Touch Menu , Setup , Local , and Time Zone . The Time Zone Setup screen displays.
2.
Touch the desired time zone from the list. Use the Up or Down arrows if necessary to display additional
time zones.
3.
Select the Auto Adjust for Daylight Savings option to allow Viper to automatically adjust for daylight
savings.
4.
Touch OK to save the displayed selections and return to the main screen.
Display Units
Select the desired unit system for use with the Viper Pro:
1.
Touch Menu , Setup , Local and Units . The Display Units screen will be displayed.
2.
Select English (units displayed in feet, miles, ounces, etc.), Metric (units displayed in meters, kilometers,
liters, etc.), or Turf (English measurement system in units per 1000 square feet) for unit displays on the
Viper Pro.
3.
Touch OK to save the displayed settings.
4.
Proceed to the Product Control Type section on page 38 to continue setting up the Viper Pro.
•
Language
•
Time Zone
•
Display Units
•
Product Control Type
•
Speed Sensor Type
and Cal
•
Application and
Control Valve Type(s)
•
Rate Cal(s)
•
Meter Cal(s)
•
Valve Cal(s)
•
Fan Cal
•
Section Setup
Profiles