Raven Hagie Hawkeye STS, Руководство по установке, Страница: 22 / 52

C
HAPTER
5
18 Hagie Hawkeye® Installation Manual
1. Locate the large, round connectors on the primary boom cables (refer to the Kit Contents section on page 6).
Route the primary boom cables so the connector with female pins is located at the mid-boom fold point of the
left or right boom and will connect to the secondary boom cable.
FIGURE 4. Primary Cable Ends
2. Starting at the center of the implement, feed the female receptacle end of the primary boom cable through the
boom framework along existing cable or plumbing runs and through any existing cable retention devices as
appropriate.
3. Connect the large, round connector on the primary cable to the secondary cable.
4. Adjust the primary and secondary boom cables to ensure sufficient slack around the mid-boom fold point and
allow each cable to reach nozzle control valves near the folding point.
5. Secure the boom cables using zip ties to protect the connector from damage during folding and unfolding
operations.
6. Connect the valve branches to the nozzle control valves, starting with the valve on the primary boom segment
furthest from the center of the implement.
7. At each valve branch, adjust the cable as necessary to provide slack between nozzle control valve connections
and use zip ties to secure the cable at each valve branch. Refer to Figure 7 on page 17. The large, round
connector with male pins on the primary boom cable should reach to the center of the implement after all
nozzle control valves are connected.
8. Repeat this procedure to route the primary boom cable on the opposite boom.
Female Receptacle
To Secondary Boom Cable/Mid-Boom Fold Point
Male Connector
To Center Rack/Chassis Connector