6
2 - Marker Raise/Lower Function Switch.
Toggle the marker function switch to
raise or lower the implement markers as determined by the Marker Mode switch.
To utilize the automatic marker control mode during an active job:
1. Toggle the Marker Mode switch to the AUTO position.
2. Toggle the Marker Function switch to the down position to lower the first marker.
3. At the end of the swath, toggle the Function switch to the up position to raise the
first marker.
4. When starting the next swath, toggle the Function switch to the down position to
lower the second marker in sequence.
3 - Tool Bar Raise/Lower Switch.
In plant or field mode, hold the Tool Bar switch
in the up position for at least two seconds to automatically raise the implement to
the field high limit position. Hold the Tool Bar switch in the down position for at
least two seconds to automatically lower the implement for 10 seconds.
4 - Auxiliary (AUX) Controls Switch.
Toggle the AUX switch on (I) or off (O) to
engage the fan or vacuum system or a down pressure control system connected
to the OmniRow system for seed handling and singulation.
5 - Lights Switch.
The Lights switch may be connected to a work light system or
provide auxiliary output for general purpose use.
6 - Section Switches.
The 3-way selectable section switches may be used to
toggle each section (up to four individual sections).
The section switches may be used to toggle up to ten individual sections. Raven
field computers are also capable of controlling additional sections using the
section mapping feature to group sections to the same switch. Refer to the field
computer
Installation and Operation Manual
for additional information.
Note:
Envizio Pro software version 3.5 or newer is required to access section
mapping. Contact a local Raven dealer for additional information.
Each of the four section switches may be toggled individually to one of the three
following positions:
• ON - manually control the section on. AccuBoom control of the section is
disabled and will not automatically control this section based on coverage, zone
maps or field boundaries.
• ACCU - AccuBoom automatic section control is enabled for the section. If
installed and properly set up for the active job, the AccuBoom features will
automatically turn sections on or off based upon previous coverage, zone maps
or field boundaries created or active in the job.
Refer to the control console or field computer operation manual for more
information about using the AccuBoom system.
• OFF - manually control the section off. This section will remain off regardless of
AccuBoom control features.
Note:
Leave the section switch in the off position for any sections not connected
or controlled by the Raven control console or field computer.
