Raven AccuFlow Vortex, Инструкция по установке и эксплуатации

Страница: 42 / 98

CHAPTER 3
38 AccuFlow™ Vortex and AccuFlow™ HP+ Installation and Operation Manual
ACCUFLOW™ VAPOR AND APPLICATOR PLUMBING INSTALLATION
The following will step through the final system connections for the AccuFlow Vortex cooler and NH
3
plumbing.
Generic Control valves used with liquid systems are not acceptable for NH
3
. Valves specially designed
for NH
3
are required. Special NH
3
valves can be used for other applications; i.e. herbicides,
insecticides, and liquid fertilizer.
1. Connect the hose barb fittings to the vapor ports on the cooler as shown below.
FIGURE 29. AccuFlow Cooler Vapor Tube Installation
2. Connect vapor tube hoses to vapor ports, tee and steel vapor tubes.
3. Weld vapor tubes provided with the kit to the back of liquid tubes. Vapor tubes should be spaced out evenly
across the tool bar. Avoid connecting vapor tubes on wheel tracks and adjacent rows if possible.
4. Route 3/4” tubing from the 3/4” cooler vapor ports to the vapor tube tee as shown in figure. Cut tube lengths
in equal lengths and allow enough hose to avoid kinking at any folding points. Connect one end of the vapor
DANGER
Anhydrous ammonia in vapor form can cause
serious injury or death. Pipe joints must be
properly sealed with PTFE pipe thread sealant, or
an equivalent thread sealant, to prevent leaks.
DANGER
Anhydrous ammonia in vapor form can cause
serious injury or death. Pipe joints must be
properly sealed with PTFE pipe thread sealant, or
an equivalent thread sealant, to prevent leaks.
Vortex Cooler
1” Vapor Port (Each Side)
3/4” Vapor Hose
(Not Supplied)
Vapor Rows with
Steel Vapor Tubes
Applicator Knife
Orifice (Optional,
Not Supplied)
Toolbar