Raven AccuBoom, Калибровка и руководство по эксплуатации

Страница: 13 / 24

CHAPTER
3
Manual No. 016-1001-087 Rev. E 9
CHAPTER 3
CALIBRATION
ACCUBOOM™ CALIBRATION OVERVIEW
After installing the AccuBoom feature, verify that any switch hardware for controlling section on/off valves controls
the expected section valves when the switch is toggled.
NOTE: AccuBoom will require a constant 12 V on and 0 V off signal to properly monitor and control section
status during field operations. Pulsed or momentary switches will not work with the AccuBoom
feature.
For best results controlling liquid application systems, ensure spray tips, product strainers, or filters are clean and
unobstructed. Use clean water to test and verify the AccuBoom installation.
CALIBRATION
Prior to using the AccuBoom feature during a field operation, the system should be calibrated or tuned for each
product and the control hardware connected to the control system.
ACCUBOOM™ LOOK AHEAD SETTINGS
The AccuBoom “look ahead” settings are used to adjust how far ahead of the current equipment position the
system is allowed to scan for coverage or zone map changes. The off look ahead and on look ahead values may be
used to help compensate for the time it takes for valves to close or to establish a spray or spread pattern when
turning sections on.
NOTE: Setting the look ahead values too high may cause valves to begin opening or closing too early. This
may cause skips, overlaps, or undesirable product application in some areas. Generally, a value
between 1 to 2 seconds will yield best results. Look ahead settings should not exceed 5 seconds.
Do not enter negative values for either the on or off look ahead values.
To set up the AccuBoom look ahead settings:
1. Touch the Edit icon in the Machine Configuration panel to expand the panel.
Edit AccuBoom
AccuBoom
Settings