Page
12
of
26
Printer manual
Remove the remaining paper using the Paper Feed button,
do not pull paper out of the rear of the printer
mechanism
.
Reel off a few centimetres from a new roll of paper and check that the end has a clean straight edge (see
drawing 1).
Slide the leading edge of the paper through the paper entry slot, with the leading edge of the paper feeding
forwards from the bottom of the roll, until you feel resistance.
Press the paper feed button and feed the paper through the printer mechanism. (see drawing 2) Keep the
paper feed button depressed until enough paper is fed through the printer mechanism to pass through
the paper exit slot.
Slide the new paper roll in the paper cup and close the lid.
Inkt ribbon change
In order to open, squeeze the lid carefully sideways and pull it up. To avoid damage, do not use
eccesive force.
Remove the old ribbon by gently pulling at the ends of the plastic housing. See picture 1.
Place the new ribbon (see picture 2)in the same position. Make sure the paper is between the ribbon and
the plastic ribbon housing. See picture 3.
Gently press the ribbon holder on its place by pushing on top of the ends. See picture 4.
Picture 1
Picture 2
