Ratio CR800M, Руководство пользователя

Страница: 38 / 44

38
be connected to
the cleaner. Push
the switch to the
vacuum position,
the cleaner will
imbibe the sawdust
through the
vacuum adapter.
• As a suction mechanism for the suction of
cutting dust.
NOTE: You should connect the vacuum adapter
to the cleaner when y ou use the sawdust
vacuum function.
• As a blower for blowing cutting dust away
from the holes of the blade guard during cutting
operation.
16. LASER GUIDE AND LED LIGHT (See N)
The laser device (17) can provide a beam in the
same plane as the blade, which projects onto the
work piece to generate a line. The saw blade can
be directed to follow the line in order to align the
cut with the line.
The LED light can provide light environment in
somber places.
Times
you
de-
press
the
on/off
switch
for
laser
and
LED
light
Zero Once twice Three
times
Four
times
Laser
device
Off On On Off Off
LED
light
Off Off On On Off
wORKINg hINTS FOR
yOUR JIg SAw
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and
run no Load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speeds.
GENERAL
Always use a blade suited to the material and
material thickness to be cut. Always ensure the
work–piece is firmly held or clamped to prevent
movement. For easier control, use low speed to
start cutting, then increase to correct speed.
Any movement of the material may affect the
quality of the cut. The blade cuts on the upward
stroke and may chip the uppermost. Ensure your
uppermost surface is a non-visible surface when
your work is finished.
CUTTING LAMINATES
Use a fine tooth blade when cutting most
laminates and thin wood materials. To reduce
edge chipping, clamp pieces of waste wood at
both ends on both sides and cut through the
wood during cutting
.
CIRCLE CUTTING
Do not use the
pendulum action
when cutting tight
circles or angles.
Plunge Sawing
Plunge cutting may
be used only on
soft materials such
as wood, aerated
concrete, gypsum
plaster boards,
etc.!
Use only short saw
blades.
Place the front
edge of the base plate on the workpiece and
switch on. Press the machine firmly against the
workpiece and plunge the saw blade slowly into
the workpiece.
As soon as the complete surface of the base
plate rests on the work piece, continue to saw
along the cutting line. (See fig O, P)
METAL CUTTING
Use a finer tooth blade for ferrous metals and a
coarse tooth blade for non-ferrous metals. When
cutting thin sheet metals always clamp wood on
both sides of the sheet to reduce vibration or
tearing of the sheet metal. Both wood and sheet
metal must be cut. Do not force the cutting blade
when cutting thin metal or sheet steel, as they
are harder materials and will take longer to cut.
Excessive blade force may reduce the life of
the blade or damage the motor. To reduce heat
during metal cutting, add a little lubricant along
the cutting line.
O
p
N