Ratio CR800M, Руководство пользователя

Страница: 34 / 44

34
8. Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
9. Fully unwind cable drum extensions to avoid potential overheating.
10. When an extension cable is required you must ensure it has the correct ampere rating for your
power tool and is in a safe electrical condition.
11. Ensure your mains supply voltage is the same as indicated on the rating plate.
12. Your tool is double insulated for additional protection against a possible electrical insulation failure
within the tool.
13. Always check walls, floors and ceilings to avoid hidden power cables and pipes.
14. After long working period, external metal parts and accessories could be hot.
15. Only withdraw the blade from the cut when the blade has been stopped moving.
16. The pivoting blade foot must be held firmly against the material being cut to reduce saw vibration,
blade jumping and blade breakage.
17. Before cutting, check the cutting line is free of nails, screws, etc.
18. If possible, ensure the work-piece is firmly clamped to prevent movement.
19. Never stop the cutting blade by applying side pressure to the blade.
20. Your Jigsaw is a hand held tools, do not clamp your Jigsaw.
WARNING: Some dust particles created by power sawing, contain chemicals known to cause
cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•
Lead from lead-based paints.
•
Crystalline silica from bricks and cement and other masonry products.
•
Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending upon how often you do this type of work. To reduce
your exposure to these chemicals:
•
Work in a well-ventilated area.
•
Work with approved safety equipment, such as those dust masks that are specially designed to filter
microscopic particles.
gENERAL SAFETy wARNINgS FOR yOUR LASER
WARNING: Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in serious injury.
Save all warnings and instructions for future reference.
These lasers do not normally present an optical hazard although staring at the beam may
cause flash blindness.
Do not stare directly at the laser beam. A hazard may exist if you deliberately stare into the
beam, please observe all safety rules as follows:
1. The laser shall be used and maintained in accordance with the manufacturer’s instructions.
2. Never aim the beam at any person or an object other than the work piece.
3. The laser beam shall not be deliberately aimed at another person and shall be prevented
from being directed towards the eye of a person for longer than 0.25 seconds.
4. Always ensure the laser beam is aimed at a sturdy work piece without reflective surfaces, e.g
wood or rough coated surfaces are acceptable.
Bright shiny reflective sheet steel or similar is not suitable for laser applications as the reflective
surface may direct the laser beam back at the operator.
5. Do not change the laser device with a different type. Repairs must be carried out by the
manufacturer or an authorized agent.
6. CAUTION: Use of controls or adjustments other than those specified herein may result in
hazardous radiation exposure.
Additional safety warning for class 2 laser
The laser device fitted to this tool is class 2 with a maximum radiation of 1mW and 650nm
wavelength.
CLASS 2 LASER RADIATION, DO NOT STARE INTO BEAM