Ratio CR800M, Руководство пользователя

Страница: 37 / 44

37
tighten both screws to lock into position. (See G)
8. ROLLER GUIDE
Ensure the blade
is located and
runs smoothly in
the groove. (See
F) Otherwise the
pendulum function
will not work
correctly and the
blade will not be supported during cutting.
9. PENDULUM
ACTION
CONTROL
The pendulum
action varies the
forward cutting
angle of the blade
for increased
cutting efficiency. This can also be adjusted
during no load running. Refer to the chart 2 for
more details. Do not use excessive blade force
when cutting with the pendulum action. The
blade cuts on the upward stroke only (See H).
Chart 2
0 Thin materials. Fine cuts. Tight curves.
1 Hard materials, (e.g. steel & chipboard)
2 Thick materials (e.g. wood) & plastic
3 Fast cuts (e.g. softwood). Cutting in the
direction of the wood grain.
10. ANGLE PLATE
Adjusting the angle of the base plate enables
bevel cutting. The base plate must always be held
firmly against the materials being cut to reduce
saw vibration, blade jumping or blade breakage.
11. PLASTIC
FOOT PLATE
PROTECTION
(See I)
Your tool is
equipped with
base plate
protection that protects finer surface.
To attached, hook the protection over front of
base plate and snap into base plate.
12. BASE PLATE ANGLE ADJUSTMENT (See
J, K)
Use a hex key (3). First loosen the bolts securing
the base plate
and pull the base
plate out of the
slots (See J). For
preset angles
rotate so the lines
of the angle on
the base plate
and angle plate
(9) superposition
at the desired
angle (0, 15, 30,
45) (See K). For
other bevel angles,
rotate to your
desired angle (use
a protractor scale). Following one of the above
procedures, hold the base plate in position and
firmly tighten the bolts to clamp the base plate at
that angle. Finally, check the angle and ensure
the base plate is firmly clamped. The angle
markings on the base plate are accurate for
most general purposes but it is recommended for
accurate work to
set the angle with
a protractor and
make a test cut on
other material.
13. VACUUM
ADAPTER
The adapter (22) rotates anti-clockwise inside the
housing and locks in position by a groove inside
the housing (See L). The adapter must then be
connected to a suitable external dust extraction
machine.
14. PROTECTION FINGER
The finger is located in front of the blade holder.
Whilst working, it will help prevent accidental
contact with moving blade.
15. DUST BLOWER SWITCH (See M)
The sawdust blower device leads an air jet to the
saw blade. The air
jet avoids sawdust
from covering the
cutting line during
operation.
The sawdust
vacuum device can
I
K
M
L
H