37
Screw the Belt clip on the tool with the screw
provided in the plastic bag. The Belt clip can be
hooked on your belt or pocket, etc.
B1
B2
2. ON / OFF SWITCH (SEE FIG. C)
Depress the On/Off switch to start and release
it to stop your drill. The on/off switch is fitted
with a brake function which stops your chuck
immediately when you quickly release the switch.
It is also a variable speed switch that delivers
higher speed and torque with increased trigger
pressure. Speed is controlled by the amount of
switch trigger depression.
WARNING: Do not operate for long
periods at low speed because excess
heat will be produced internally.
C
3. SWITCH LOCK
The switch trigger can be locked in the OFF
position. This helps to reduce the possibility of
accidental starting when not in use. To lock the
switch trigger, place the rotation control in the
center position.
4. REVERSIBLE (SEE FIG. D1, D2)
For drilling and screw driving use forward rotation
marked “
” (lever is moved to the left).
Only use reverse rotation marked “
”
(lever is moved to the right) to remove screws or
release a jammed drill bit.
WARNING: Never change the direction
of rotation when the chuck is rotating,
wait until it has stopped!
D1
D2
5. TWO-SPEED GEAR CONTROL (SEE FIG. E)
The drill has a two-speed gear control designed
for drilling or driving at LO (mark is 1) or HI (mark
is 2) speeds. A slide switch is located on top of
the drill to select either LO or HI speed. When
using the drill in the LO speed range, the speed
will decrease and the drill will have greater power
and torque. When using the drill in the HI speed
range, the speed will increase and the drill will
have less power and torque.
E
Gear I
Low speed range: for screwdriving or working
with large drilling diameter
Gear II
High speed range: for working with small drilling
diameter
WARNING: To prevent gear damage,
always allow the chuck to come to a
complete stop before changing the direction
of rotation or the two-speed gear control.
