45
1 flashing light
reserve
11. BELT HOOK (SEE FIG. J1, J2)
Screw the Belt Hook (8) on the tool with the
screw provided in the plastic bag. The Belt
Hook can be hooked on your belt or pocket,
etc.
12. DRILLING
When drilling into a hard smooth surface, use a
center punch to mark the desired hole location.
This will prevent the drill bit from slipping off
center as the hole is started.
Hold the tool firmly and place the tip of the bit at
the point to be drilled.
Depress the switch trigger to start the tool.
Move the drill bit into the workpiece, applying
only enough pressure to keep the bit cutting. Do
not force or apply side pressure to elongate a
hole.
If you want to activate the drill function (For
drilling metal wood or plastic), turn the torque
adjustment ring on the drill position.
If you want to activate the impact function(For
masonry or concrete), turn the torque adjustment
ring on the hammer position.
Tungsten carbide drill bits should always
be used for concrete and masonry.
When drilling in metal, only use HSS drill bits
in good condition. Always use a magnetic
bit holder (not included) when using short
screwdriver bits. When screw-driving, apply a
small quantity of liquid soap or similar to the
screw threads to ease insertion.
13. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop.
Relieve the load on the machine immediately and
release the on/off switch. Then you can restart
the tool soon.
14. TEMPERATURE DEPENDENT OVERLOAD
PROTECTION
When using as intended for the power tool
cannot be subject to overload. When the load
is too high or the allowable battery temperature
is too hot, the electronic control switches off the
power tool until the temperature is in the optimum
temperature range again.
15. PROTECTION AGAINST DEEP
DISCHARGING
The Li-ion battery is protected against deep
discharging by the “Discharging Protection
System”. When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
16. DISPOSAL OF AN EXHAUSTED BATTERY
PACK
To preserve natural resources, please recycle or
dispose of the battery pack properly. This battery
pack contains Lithium batteries. Consult your
local waste authority for information regarding
available recycling and/or disposal options.
Discharge your battery pack by operating your
drill, then remove the battery pack from the drill
housing and cover the battery pack connections
with heavy-duty adhesive tape to prevent short
circuit and energy discharge. Do not attempt to
open or remove any of the components.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is
on top of the trigger, is positioned in the lock
function. Unlock the forward/reverse rotation
control by putting it into the required rotation
position. Push the trigger and the drill will start to
rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting
ring, you can find the torque-adjusting ring
J1
J2