42
OPERATING INSTR
UCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
BEFORE PUTTING INTO OPERATION
CHARGING THE BATTERY PACK (SEE FIG. A)
NOTE:
a) Do not use any charger other than that
specifically provided for use with the
equipment.
b) If the battery pack is very hot you must
remove your battery pack from the
charger and allow time for the battery to
cool down before recharging.
c) The battery in your new tool is not
charged when it leaves the plant.
Therefore it must be full charged before
using the first time
d) Please charge the battery to reach full or
no less than half charge before storage. If
the tool will not be used for long periods
of time, charge the battery every 3-6
months
1). Plug the charger into an appropriate
outlet.
2). Place the battery pack into the charger
3). When charging is completed, unplug the
charger and remove the battery pack.
Note: If the battery pack is locked in the
charger, press the battery pack release
button and remove it.
WARNING:
When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
Light
ON/OFF
flash
Status
Red on
Charging
Red flash
- - - -
Defective Bat-
tery
Green on
Fully Charged
Green flash
- - - -
Hot/Cold Delay
OPERATION
1. INSTALLING AND REMOVING THE
BATTERY PACK
a) TO REMOVE THE BATTERY PACK (SEE
FIG. B1)
Depress the Battery Pack Release Button
(7) firmly first and then slide the Battery
Pack out from your tool.
b) TO INSTALL THE BATTERY PACK (SEE
FIG. B2)
Slide the fully charged Battery Pack onto
the tool with sufficient force until it clicks
into position.
A
B1