Ratek OM8 Orbital Shaker – User Manual
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Page 12 of 15
Cleaning The Orbital Shaker
CAUTION
Do not use alcohol based cleaners or solvents on the Orbital Shaker as these may break down certain components of it’s
construction, reducing it’s life and potentially creating a hazardous situation. Use only a mild household detergent when cleaning
the Orbital Shaker.
CAUTION
If the Orbital Shaker has been used with any dangerous, chemical or biological substances it should be decontaminated prior to
cleaning. Decontaminate the Orbital Shaker using a decontamination procedure appropriate to the contaminant, however in all
cases ensure the following :
-
No decontamination or cleaning agents are used which could cause a hazardous situation to arise as a result of a
reaction with parts of the Orbital Shaker or with any materials contained in it. For example, substances that may
compromise the integrity or function of electrical insulation, electrical components or other components.
-
Ratek are consulted prior to decontamination or cleaning being undertaken if there is any doubt about the compatibility
of decontamination or cleaning agents with parts of the Orbital Shaker or with any materials contained in it.
CAUTION
When cleaning the unit, only use a damp sponge.
Do not use a sodden wet sponge.
Do not make any part of the control panel,
any exposed control or receptacle or any part of the Orbital Shaker excessively wet. If these receptacles and controls remain wet
once electrical power is restored they can create a hazardous situation sufficient to cause serious injury or risk to life due to
electrical shock. Always ensure the unit and in particular all controls and receptacles are completely dry before restoring
electrical power.
-
Unplug the equipment from the mains power supply outlet.
-
Allow the Orbital Shaker to air dry, or use a dry cloth to remove water from all surfaces.
-
Using a mild detergent and damp sponge, clean around the platform and the top of the machine as well as the control panel,
ensuring no water is allowed to get behind any switches.
-
Wipe the underside of the rubber feet to ensure the mixer will remain securely in place during operation.
-
Once the Orbital Shaker is clean, use a soft dry cloth to dry all surfaces of the mixer paying particular attention to any
controls or receptacles.
-
Once cleaning has been completed, it may be re-installed and operated in accordance with this User Manual.
Maintenance
-
Unplug the equipment from the mains power supply outlet.
-
Under good light, carefully inspect the mains power lead and check for any signs of wear, over-extension or damage. If you
believe the lead to be damaged in any way, contact your supplier.
-
Carefully check to ensure all safety warning labels are affixed and in a good readable condition. Refer to the section in this User
Manual titled “Safety Labels & Markings” for a table of factory-fitted warning labels. If any labels are missing, illegible or
otherwise not functional, contact your supplier to obtain new replacement labels before operating the equipment.
-
Ensure all controls and switches are good condition. If any are found to be loose or not operating correctly, have an authorized
service technician repair the unit before operating it.
CAUTION
If any controls or switches are found to be loose or in poor condition, do not operate the equipment. Loose or damaged electrical
controls and connections may create a hazardous situation sufficient to cause serious injury or risk to life. Refer the equipment to
an authorized service technician for repair.
