6
https://www.rasor-cutters.com
USE
2 USE
2.1
Manual mode
To use the cordless electric cutter manually:
–
Disconnect the battery from the charger (if charged) as de-
scribed in section 2.2;
–
Attach the battery to the motor, fitting it as indicated on the
battery itself;
–
Lay out the material on a table;
–
Position the material above the cutting base;
–
Press the button under the handle to start the cutter;
–
Push the cordless electric cutter in the direction of the re-
quired cut, while keeping the material taut to avoid it curling
up in the front part of the cutter.
–
To cut neatly along a pre-marked line, we recommend using
the tip (1) as a guide.
1
l
WARNINGS
Apply pressure uniformly to the cordless electric cutter.
2.2
Charging the batteries
a
CAUTION
Always check the charger voltage against the mains
voltage for the country of use.
When the battery is flat, recharge it using the docking station
supplied with the device only.
The docking station must be connected to the standard charg-
er (with European or American plug) also supplied with the
cutter.
Release the battery (1) from the motor by pressing the orange
buttons (2) above and below the battery, then insert it in the
docking station (3).
Never use batteries other than the one supplied (rechargeable
3.7 V with Li-ion
®
technology).
You can check the charge level on the docking station and
charger:
–
battery charging (red)
–
battery fully charged (green)
Using the standard CH36 charger (European plug) or CH3601
(American plug) charger, the battery takes approximately 4
hours to charge fully.
2
1
3
1
a
CAUTION
Only ever use the charger supplied (100-240VAC, 50/60 Hz,
0.4A max - Output: 4.2V, 2A).
