RASOR GRT10, Руководство пользователя

Страница: 10 / 15

EN
13. LUBRICATION
Every 3-4 working days it is necessary to lubricate the
pair of gears. To carry out this operation, remove the
protective plug “A” located on the motor support of the
cutting unit and fill it with lubricating grease Rasor.
Screw plug “A” again a few turns. Screw plug “A” a few
turns every 2-3 working days (see picture 9).
The blade must never be dirty with grease or oil.
9
WARNING
A
12. BLADE SHARPENING
After many hours of a continuative use of the cutting
unit, or if it would not be able to cut anymore, it is
necessary to sharp the blade.
To carry out this operation, start the blade and press
sharpener “2” located on it for 3-4 seconds (by pressing
push button “1”, as shown in picture 7).
Repeat the operation 2-3 times.
If the sharpening operation is not effective, check
the wear of emery grinding wheel “3” (see picture 8).
If emery grinding wheel “3” is too worn or dirty, replace
it.
1
2
8
3
7
26
Enfocus Software - Customer Support