RASOR FP861V, Руководство пользователя

Страница: 10 / 16

EN
10
12. BLADE SHARPENING
After using the cutting unit for some hours without
interruption, or if its cutting capacity is reduced, it is necessary
to sharpen the blade.
To carry out this operation, start the blade and press sharpener
“2” on the blade itself (by means of push button “1”, as shown
in picture 7) for 3-4 seconds. Repeat this operation 2-3 times.
Check periodically that the grinding wheel is not worn or dirty.
If it is worn or its surface is irregular, replace it.
13. LUBRICATION
There must not be stains of grease or oil on the blade.
8
WARNING
2
7
A
1
Every 3-4 working days, it is necessary to lubricate the gear
pair. In order to carry out this operation, remove protective
plug “A” located on the head of the cutting unit and fill it
with Rasor lubricating grease. Screw plug “A” again a few
turns. Screw plug “A” a few turns every 2-3 working days
(see picture 8).
Once the plug is screwed until the end, fill it again.