EN
11
If the blade is no more able to cut (even after repeating
the sharpening operation several times) it is necessary
to replace it. To carry out this operation, use butterfly
wrench “
1
” and drift “
3
” locking the blade (shown in
picture 8).
To replace the blade, proceed as follows:
1) Use some protective gloves in compliance with
Italian Legislative Decree 81/08.
2) Remove the adjusting knob “
A
” of the left
protection cover “
C
” by removing the two washers
“
B
” (see picture 9).
3) Insert drift “
3
” into hole “
D
” (see picture 10), in
order to lock the blade (the hole on the blade
must correspond with the one on the structure).
4) Use butterfly wrench “
1
” to unscrew nut “
E
” and
remove blade “
F
” (see picture 10).
5) Replace the worn blade with the new one “
2
”,
being careful to center the blade on the gear, in
the correct position; we remind you to assemble
it so that the side with the writing Rasor can be
seen by the operator.
6) Assemble all the components again and carry out
the sharpening.
13. BLADE REPLACEMENT
9
8
10
A
B
C
F
1
E
3
D
2
1
3