PX3TS Transfer Switch Quick Setup Guide
8
QSG-PX3TS-0A-v2.6-E
255-80-0032-00 RoHS
e. After enabling the IPv4 or IPv6 protocol in the earlier
step, configure the IPv4 or IPv6 network parameters.
To set
Use this command
IPv4
configuration
method
network ipv4 ipConfigurationMode
<mode>
<mode> =
dhcp
(default) or
static
IPv6
configuration
method
network ipv6 ipConfigurationMode
<mode>
<mode> =
automatic
(default) or
static
Configure
the
preferred host name for the IPv4
DHCP or IPv6 automatic configuration.
Note: The <version> variable in all of the following
commands is either
ipv4
or
ipv6
, depending on the type of
the IP protocol you have enabled.
To set
Use this command
Preferred host
name (optional)
network <version>
preferredHostName <name>
<name> = preferred host name
Tip: To override the DHCP-assigned DNS servers with
those you specify manually, type this command:
network <version> overrideDNS <option>
where <option> is
enable
or
disable
. See the table
below for the commands for manually specifying DNS
servers.
For the static IP configuration, configure these
parameters.
To set
Use this command
Static IPv4 or
IPv6 address
network <version> ipAddress <ip
address>
<ip address> = static IP address
IPv4 subnet
mask
network ipv4 subnetMask <netmask>
<netmask> = subnet mask
IPv4 or IPv6
gateway
network <version> gateway <ip
address>
<ip address> = gateway's IP address
To set
Use this command
IPv4 or IPv6
primary DNS
server
network <version>
primaryDNSServer <ip address>
<ip address> = IP address of the primary
DNS server
IPv4 or IPv6
secondary DNS
server (optional)
network <version>
secondaryDNSServer <ip address>
<ip address> = IP address of the secondary
DNS server
9. To quit the configuration mode, type either of the following
commands, and press Enter.
Command
Description
apply
Save all configuration changes and exit.
cancel
Abort all configuration changes and exit.
The # prompt appears, indicating that you have quit the
configuration mode.
10. To verify whether all settings are correct, type the following
commands one by one.
Command
Description
show network
Show network parameters.
show network ip
all
Show all IP configuration
parameters.
show network
wireless
details
Show all wireless parameters.
Tip: You can type "
show network wireless
" to display
a shortened version of wireless settings.
11. If all are correct, type
exit
to log out of the PX3TS. If any
are incorrect, repeat Steps 7 to 10 to change network
settings.
QS Rule
Wireless Configuration
USB Wireless LAN Adapters
The following table lists USB wireless LAN adapters that the
PX3TS supports.
Wi-Fi LAN adapter
Supported 802.11 protocols
Proxim Orinoco 8494
A/B/G
Zyxel NWD271N
B/G
Edimax EW-7722UnD
A/B/G/N
Raritan USB WIFI
A/B/G/N