Raritan EMX Quick Setup Guide
11
QSG-EMX-0I-v2.5.0
255-80-6106-00 RoHS
Connect the discrete detectors/switches while the terminal
module is attached to the EMX.
Connect the discrete detectors/switches while the terminal
module is separated from the EMX.
It is not guaranteed that all third-party detectors/switches
are compatible with the EMX device. You need to test the
compatibility after properly installing them.
Note: If the detector/switch plugged into the contact closure
sensor is Raritan's floor water sensor, verify that the total
cable length from the port of the EMX to the water detector
does not exceed 30 meters/100 feet.
To make connections when the terminal module is
attached to the EMX console sensor:
1. Plug one Raritan environmental sensor into one of the
SENSOR ports on the EMX device. To connect additional
sensors, repeat this step.
2. Strip the insulation around 12mm from the end of each
wire of discrete detectors/switches.
3. Fully insert each wire of both detectors/switches into each
termination point.
Plug both wires of a detector/switch into the two
termination points to the left.
Plug both wires of the other detector/switch into the
two termination points to the right.
4. Use an appropriate screw driver to tighten the screws
above each termination point until the connected wires are
securely fastened.
To make connections when the terminal module is
separated:
1. Loosen the two screws on each side of the terminal
module.
Note: The two screws are not removable, so just loosen
them.
2. Separate the terminal module from the CONTACT
SENSOR panel.
3. Strip the insulation around 12mm from the end of each
wire of discrete detectors/switches.
4. Fully insert each wire of both detectors/switches into each
termination point.
